machines miter cut up to 75 degrees from 0 (90 degree cut). Cut length on 2 x
material with fence at standard position (single point of cut) - 12 inches.
Typical cuts are 90 degrees on 2x12s - 30 degrees on 2x10s - 45 degrees on 2x8s - 60
on 2x6s - 70 degrees on 2x4s.
machines are capable of cutting 2x6s on edge for bevel cuts. 4x4s cut with ease.
Our most popular unit, this machine delivers the performance that 75% of
- 20" Carbide Tipped Saw
- 10 HP, tefc, 3 phase arbor
- 2 Hand (non anti-tie down)
- Magnetic starter in dust proof
- Saw access door safety switch
- "Quick Adjust Rod"
for proper clamp/guard height
- Large easy to read scales 0-75
or 90-15 degree
- Air supply shut off valve
- OSHA safety blow gun
- Solid or roller infeed & outfeed
- Manual & Air operated
4" high x 9" long swing up material stops.
automatic material stop gauge complete with interlock kit, table and
hardware installed & tested with new machine purchase.
- Air over Oil control of saw
- Laser light (shows blade
position on top surface of work piece with clamp/guard raised)
- Anti-tie down cycle control
- 3 position fence rails -
normal ( single point cutting at fence line) - 1-3/4" rearward
for center lining 2 x 4s & 2-3/4" rearward for centerline
cutting 2 x 6s
Only quality components which are readily
available from Vista Machines or any number of supply houses across the country
are used in the manufacture of "ANGLE BOSS" cut off
saws. Made with pride in the U.S.A.
For More Information, please contact:
Machinery Sales, Inc.
PO Box 11397 / 3219 N. 2nd St.
Minneapolis, MN 55411-0397
FREE: (800) 344-EIDE (3433)
Phone: (612) 521-9193 / Fax:
New Machine Sales & Inquiry