For More Information,
Machinery Sales, Inc.
PO Box 11397 / 3219 N. 2nd St.
Minneapolis, MN 55411
TOLL FREE: (800) 344-3433 (EIDE)
Phone: (612) 521-9193 / Fax: (612)
Email: New Machine Sales
Cast iron stud locating flippers are an exclusive of Triad.
The flippers are counterbalanced into the upright position. When
need be, they lay down out of the way. Stud locators can be
12", 16" or 24" on center and be color coded. The
locator brackets are slotted in order to assure exact center placement
during table setup.
The latest state of the art in operator controls for raising and
lowering the roller conveyor and for activating the power width adjust for
wall height changes as well as power clamping the walls prior to nailing.
The operator simply touches the ribbon control to activate it from any
position along the table's length. Saves operator steps and time.
A drum switch is used to activate the standard electric power width
adjust from 6'9" to 9'3" and to clamp the wall square prior to
nailing. A throw switch is used to raise and lower the roller
The tool dollies ride on solid steel rails. This solid rail system
is bolted to the main framework of tubular steel for engineered strength.
Two bolts are used in order to allow for precise adjustment of the rail
for lining up the tool dollies. The nycoil air line for the tool
carriage also attaches to the down rigger to keep the air line off of the
The roller conveyor is nested below the working surface to protect the
rollers. When activated, the rollers rise up raising the framed wall
out of the stud locators for removal of the end of the table.
A solid squaring lip is provided the full length of the table for squaring
Pop Up Rollers
The rollers are activated up and down by air cylinder from the under side
of the table. The air exiting from these cylinders is muffled to
enhance Triad's quiet quality. You will
also note the air cylinder uses a tubular guide body to assure the
cylinder's long life and lasting quality, eliminating the stress of the
Power Width Adjust
Rack and pinion gears are used in conjunction with an electric motor
with brake, gear box and torque limiter for a positive clamping action for
squaring walls prior to nailing. Table width adjust can be activated by a
drum switch or touch control ribbon by custom order.
- Height 28" from floor
- Width 6'9" to
9'3", 6'9" TO 10'3", 6'9" TO 12'3"H
- Working length 16', 20' 24'
(Additional lengths optional)
- Actual length 1'6" longer
than working length
- Shipping weight Approx. 2,000
pounds for 20' table
- Air required ½ NPT 10 CFM @ 90
- Electric Power 110V, 1PH